Wire Repeater
Description
The Wire Repeater is a device in Gimkit Creative that serves as a hub for wires. The appearance of the wire repeater is a gray box with indentations in it, along with a rounded red light and green lights on the side of the device. The Wire Repeater can never be seen in-game, and it has no collision in-game or in the Gimkit Creative editor. When entering the settings menu for the page, there are no tabs. The settings menu contains two options. One of them changes the delay between incoming and relaying signals, and the other sets which team is allowed to relay signals through the Wire Repeater. The Wire Repeater one of the very few devices that doesn't have any channels connected to it. The Wire Repeater was introduced May 10th, 2023, in the release of Gimkit Creative.
Settings
In the settings for the Wire Repeater, there are no tabs.
There are currently two adjustable options in the Wire Repeater.
| Tab | Dropdown? | Setting Name | Default | Setting Description (in-game) | Setting Description |
|---|---|---|---|---|---|
| N/A | No | Delay | 0.0 | When a pulse is recieved, how long (in seconds) to wait before relaying it | Set a decimal value to change how long it takes for the Wire Repeater to relay a pulse onto another wire. The value of the delay can go anywhere from 0.0 to 60.0, and the precision of the value is to the nearest tenth. |
| N/A | Yes | Allowed Team | Any Team | The wire's pulse will be blocked if the message is not from a player on this team | When you choose a team, only wire pulses from that team will go through the Wire Repeater. Any other team's wire pulse will not get relayed. Choosing "Any Team" allows for any team to relay pulses through the Wire Repeater. |
Wires
There are currently no input or output conditions for the Wire Repeater. Instead, a single. non-interactable message shows up in place.
Input Condition Message: Repeat the wire pulse!
Output Condition Message: When the wire repeater receives a pulse...
Trivia
- If you wire a Wire Repeater to another Wire Repeater, the popup asking for the conditions will not show up. This menu is still accessible by going into the wires category of one of the devices and clicking on the interaction.
